The pascom SMB Server is not only an Out-of-the-Box All-IP ready solution but can also be optionally configured using ISDN, Analog and GSM modules.
The pascom appliance is delivered with the pascom phone system server software already pre-installed. Perform the following steps only if you wish to reinstall the system!
Connect the USB stick to your compute and start Rufus. Now select the pascom Server ISO file under , select the USB stick via and finally click the :
Now you can directly connect the prepared USB stick to the USB3 port (blue port located on the back of the server).
Complete the setup and follow the on-screen instructions until you are directed to switch to your browser and start the setup wizard:
Open a browser window and go to your pascom PBX server IP address configured during the first system start. Follow the steps until you can login into the Management Interface:
If you want to use this feature, follow these steps now. Future changes are possible, but will result in changes for your users as aspects such as access to the server via the pascom client will change from a local IP address to a DNS name.
This step is required should you wish to use the pascom mobile client (iOS/Android) or desktop client to access the local pascom server from “on the go” i.e. outside of the network.
An additionnal assistant will help you to finish setting up your phone system and add / invite further users. Proceed as follows: